In addition to getting the timing right it is also important to pollard at the right height, point on the stem and using the right tools. Pollarding involves cutting the top and branches off of a tree. Normally this is done to promote resprouting at the top of the stem but in the case of our agroforest system we want to allow light into our plot for the cultivation of annual crops or fruit trees. This means that we need to cut the stem at the right height so as to shade the crops below and to give them enough time to grow and be harvested before the branches have regrown to their original length. For this purpose we are aiming to pollard at approximately 1.30 m in height, the height of somebody’s chest.
The best place to cut the stem is a couple of centimetres above or below a branch or branch scar. The reason for this is that new branches will sprout from these points. If you cut through the branch point or scar then the tissue from which new branches will develop will be damaged and new branches will be generated at the nearest point above or below it, meaning that it will be higher or lower than desired. The choice of implement is also important. Whilst it is much quicker and more natural to want to use a machete, this is not the ideal way to cut the branch. The reason for this is that it is hard to get a clean clut with a machete as Inga wood splits very easily and the split wood is vulnerable to insect and fungal infections.